ONLINE CADD 360

Preference > thermal > ok Pre-processor >element type > add/edit/delete > add > solid > quad 4 node 55 > ok > close. Pre - processor > material properties> material models > thermal > conductivity >    isotropic > KXX = 100 > exit. Pre - processor > modelling > create > area > rectangle > by 2 corners ( enter width =1, enter height =1) > ok. Pre - processor > meshing > size control > manual size  > lines > picked lines > (select two lines opposite to each other or parallel to each other) > ok > No of element divisions = 10 > apply > (select remaining two lines of the square which are also parallel to each other) > ok > No of element divisions = 10 > ok. Pre - processor > meshing > mesh > area > free > (select the area) > ok. Pre - processor > loads > analysis type > new analysis > steady state > ok. Pre - pr

Preference > thermal > ok Pre-processor >element type > add/edit/delete > add > solid > quad 4 node 55 > ok > close. Pre - processor > material properties> material models > thermal > conductivity >  isotropic > KXX = 16 > exit. Pre - processor > modelling > create > area > rectangle > by 2 corners ( enter width =1, enter height =1) > ok. Pre - processor > meshing > size control > manual size  > lines > picked lines > (select two lines opposite to each other or parallel to each other) > ok > No of element divisions = 10 > apply > (select remaining two lines of the square which are also parallel to each other) > ok > No of element divisions = 10 > ok. Pre - processor > meshing > mesh > area > free > (select the area) > ok. Pre - processor > loads > analysis type > new analysis > steady state > ok. Pre - proce

Preferences > structural > ok. Pre - processor > element type > add/edit/delete > add > shell > 3D - 4 node 181 > ok > close. Pre - processor > material properties > material model > structural > linear > elastic > isotropic > enter (EX = 50, PRXY = 0.49) > ok > materials > exit. Pre - processors > sections > shell > lay-up > add/edit > enter "thickens = 1 > ok. Pre - processor > modelling > create > key points >  in active cs > enter the below co-ordinates. Key point No X - location Y - location Z - location 1 0 0 0 Apply 2 10 5 0 Apply 3 10 15 0 Apply 4 0 5 0 apply 5 0 15 0 Ok Pre - processor > modeling

Preferences > structural > ok. Pre - processor > element type > add/edit/delete > add > beams > 2 node 188 > ok > close. Pre - processor > material properties> material model > structural > linear > elastic > isotropic > enter (EX = 0.45E5, PRXY = 0.35) > ok. Pre - processor > material properties> material model > structural > density > enter (density = 1.75e-9) > ok > materials > exit. Pre - processor > section > beams > common section > enter (ID = 1, NAME = Square, B = 0.01, H = 0.01) > ok. Pre - processor > modelling > create > key points > in active cs > enter below table. Key point No X - location Y - location Z - location 1 0 0 0 Apply 2 1.2 0 0 Ok Pre - processor > modelling > create > lines > li